Titanium Carbide Crusher Wear Parts

Right now,jaw plate, cone crusher liner and other crusher wear parts mainly use high manganese steel(Mn14,Mn18,Mn22) to manufacture.Its organization is austenite morphology, and have good work hardening performance. Under the conditions of strong impact,its surface will rapidlly hardening,its hardness can be increased from 170 ~ 225HB to 400 ~ 600HB,and the inner of crusher parts still keep the original hardness.Although high manganese or ultra-high manganese casting parts have good wear resistance,however,when crush hard stone or working under other extremely poor conditions,high manganese steel parts also not wear resistance and need exchange very frequently. This will cause production cost increasing.

In order to slove this question, FW Casting have had started to use new alloy  material-tungsten carbide manganese to cast crusher wear parts. After success to supply the new crusher replacement parts for customers, based on customer feedback. We can get the new parts span-life two or four times more than original parts under different working conditions.

Titanium Carbide Insert Cone Crusher Parts

Titanium Carbide Insert Jaw Crusher Parts

Titanium Carbide Insert Impact and Hammer Crusher Parts

Titanium Carbide

Titanium carbide, TiC, is an extremely hard (Mohs 9–9.5) refractory ceramic material, similar to tungsten carbide. It has the appearance of black powder with the sodium chloride (face-centered cubic) crystal structure. As found in nature its crystals range in size from 0.1 to 0.3mm.

Titanium carbide is used in preparation of cermets, which are frequently used to machine steel materials at high cutting speed. It is also used as an abrasion-resistant surface coating on metal parts, such as tool bits and watch mechanisms.[citation needed] Titanium carbide is also used as a heat shield coating for atmospheric reentry of spacecraft.